×

Special Offer! November Sale at DumpsCity! Get 20% Off on All Certification Exam Questions. Use Code: DC20OFF

Email Us [email protected]
LOG IN SIGN UP 0

Free Cisco 300-510 Exam Questions

Try our Free Demo Practice Tests for Comprehensive 300-510 Exam Preparation

  • Cisco 300-510 Exam Questions
  • Provided By: Cisco
  • Exam: Implementing Cisco Service Provider Advanced Routing Solutions
  • Certification: CCNP Service Provider
  • Total Questions: 216
  • Updated On: Nov 14, 2024
  • Rated: 4.9 |
  • Online Users: 432
Page No. 1 of 44
   
Add To Cart
  • Question 1
    • Which two BGP route reflector attributes should be implemented to prevent routing loops? (Choose two) 

      Answer: B,C
  • Question 2


    • Refer to the exhibit. Mid-sized company Z connected two branch offices via a multicast-enabled ISP using the BGP routing protocol. PIM was implemented to support multicast streaming between the branches via MSDP Client A cannot connect to the multicast stream source of company Z. The network engineer ran a debug on the edge of the network as shown. Which action resolves the issue?


      Answer: C
  • Question 3
    • While configuring Cisco NSF awareness, a network engineer enters the bgp graceful-restart command after the BGP session is established in a router that runs IOS XE Software. Graceful restart capabilities are not exchanged. Which two actions should be taken? (Choose two.)

      Answer: A,D
  • Question 4
    • Refer to the exhibit.
      44
      Refer to the exhibit. A network engineer configured three new PE routers to expand the network. The new routers run in the IS-IS routing protocol and reside in the data center in the same exchange as the existing routers. However, the network is now experiencing suboptimal routing. The Layer 2 configuration and VLANs are configured correctly to provide segregation between networks, but the Level 1 routes are not being converted to Level 2 routes. Which action resolves the issue?

      Answer: D
  • Question 5
    • Refer to the exhibit.
      184
      A service provider technician is working on a multicast issue for a customer. While
      checking the multicast table, the technician notices that no flags are present for the (1.1.1.1, 239.1.1.1) entry, yet flags are present for the (1.1.1.1, 232.1.1.1) entry.
      Which factor might explain this issue?

      Answer: C
PAGE: 1 - 44
   
Add To Cart

© Copyrights Dumpscity 2024. All Rights Reserved

We use cookies to ensure your best experience. So we hope you are happy to receive all cookies on the Dumpscity.